Attach light kit to ceiling fanīefore you can attach a light kit to your ceiling fan, you need to make sure it will fit. This will help prevent damage caused by pulling wires up through holes in your ceiling as you remove other fixtures below it. If your ceiling fan has an integrated light kit attached, detach it before removing all other lights. That way when you are trying to attach them back together you will be able to tell which wires go where. You’ll also want to mark each wire with tape or tags that say which terminal they connect to on each piece of hardware. As you disconnect wires from your existing light kit, label them and group them by function - for example, power in, power out, and so on. Attach wires to the new light kitīefore you take out your old light fixture, grab a picture of it to keep as a reference. Remove those screws to access an inner cover plate and wall switch (if there is one).Ĭarefully pull down on your old light kit while holding down on a new light kit to make sure you don’t yank too hard and accidentally break it. This will expose a ceiling fan box (cover), which is secured to your ceiling with two or three more screws. Then disconnect and remove any old light kit by unscrewing and removing two or three screws that hold it in place. Your next step will depend on whether you have an integrated light kit in your ceiling fan or if you have separate fluorescent lighting above.įirst, turn off your ceiling fan at the switch. Make sure all of your lights are off as well so you don’t come into contact with any accidentally powered fan parts. If you’re not sure where it is, check for a red light near one of your electrical outlets that’s probably it. This will be located in your fuse box or utility room and should look like a giant breaker switch with a red handle. Turn off your ceiling fan at your main circuit breaker. Find an electrician to help before proceeding any further. Do not try to fix a burned-out light bulb on your own. When you find the fuse that’s blown, replace it with one of similar voltage. Now check for a blown fuse by removing each fuse one at a time from its slot in your circuit breaker box (again, with power off). Also watch this video to fix this issueįirst, unplug your fan and make sure there’s no power coming from either a light switch or an electrical outlet.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |